Warning:
Use only Delco Supreme 11, GM P/N 12377967 (Canadian P/N 992667), or equivalent DOT 3 brake fluid from a clean, sealed container. Do not use fluid from an open container that may be contaminated with water. Improper or contaminated fluid could result in damage to components, or loss of braking, with possible injury.
Brake Fluid Level Indicator Switch Replacement
Brake Pipe ReplacementLiftgate Replacement
Liftgate Replacement
Callout
Component Name
Preliminary Procedures
Disconnect the electrical connectors.
Disconnect the liftgate struts. Refer to Liftgate Strut Replacement.
Remove the body lock pillar upper trim. Refe ...
Multi-Axis Acceleration Sensor Module Programming and Setup
Note:
DO NOT program a control module unless directed to by a service procedure
or a service bulletin. If the Multi-axis Acceleration Sensor or Inertia
Sensor Module (IMU) is not properly configured with the correct calibration
software, the Electronic Brake Control Module will ...
Water Outlet Installation
Clean the sealing surfaces.
Install the water outlet (2) and a NEW water outlet seal ring (1).
Caution: Refer to Fastener Caution.
Install the 3 water outlet bolts (3) and tighten to 8 Y (71 lb in).
...