Chevrolet Sonic Owner's Manual: Checking Coolant
The vehicle must be on a level surface when checking the coolant level.
It is normal to see coolant moving in the upper coolant hose return line when the engine is running.
Check to see if coolant is visible in the coolant surge tank. If the coolant inside the coolant surge tank is boiling, do not do anything else until it cools down.
If coolant is visible but the coolant level is not at or above the mark pointed to, add a 50/50 mixture of clean drinkable water and DEX-COOL coolant.
Be sure the cooling system is cool before this is done.
What to Use
Warning
Adding only plain water or some other liquid to the cooling system can be
dangerous. Plain water and other liquids, can boil before the proper coolant mixture
will. The coolant warning sy ...
How to Add Coolant to the Coolant Surge Tank
Caution
This vehicle has a specific coolant fill procedure. Failure to follow this
procedure could cause the engine to overheat and be severely damaged.
If no problem is found, check to see if coo ...
Other materials:
Body Waterleak Repair
Warning: If the vehicle interior is exposed to moisture and becomes
soaked up to the level of the sensing and diagnostic module (SDM), the SDM and
SDM harness connector must be replaced. The SDM could be activated when powered,
which could cause airbag deployment and result in person ...
Rear Side Door Trim Replacement (Sedan)
Rear Side Door Trim Replacement
Callout
Component Name
1
Rear Side Door Inside Handle Bolt Cap
2
Rear Side Door Inside Handle Fastener
Caution: Refer to Fastener Caution.
Proce ...
Air Conditioning Compressor Oil Balancing
Draining Procedure
Note: Drain and measure as much of the refrigerant oil as
possible from the removed compressor.
Drain the oil from both the suction and discharge ports of the removed
compressor into a clean, graduated container. Rotate the compressor sha ...
0.0056