Chevrolet Sonic manuals

Chevrolet Sonic Owner's Manual: What to Use

Warning

Adding only plain water or some other liquid to the cooling system can be dangerous. Plain water and other liquids, can boil before the proper coolant mixture will. The coolant warning system is set for the proper coolant mixture. With plain water or the wrong mixture, the engine could get too hot but you would not get the overheat warning. The engine could catch fire and you or others could be burned. Use a 50/ 50 mixture of clean, drinkable water and DEX-COOL coolant.

Use a 50/50 mixture of clean drinkable water and DEX-COOL coolant. This mixture:

Caution

If improper coolant mixture, inhibitors, or additives are used in the vehicle cooling system, the engine could overheat and be damaged. Too much water in the mixture can freeze and crack engine cooling parts. The repairs would not be covered by the vehicle warranty. Use only the proper mixture of engine coolant for the cooling system. See Recommended Fluids and Lubricants.

Never dispose of engine coolant by putting it in the trash, pouring it on the ground, or into sewers, streams, or bodies of water. Have the coolant changed by an authorized service center, familiar with legal requirements regarding used coolant disposal. This will help protect the environment and your health.

Engine Coolant
The cooling system in the vehicle is filled with DEX-COOL engine coolant. This coolant is designed to remain in the vehicle for 5 years or 240 000 km (150,000 mi), whichever occurs first. The fol ...

Checking Coolant
The vehicle must be on a level surface when checking the coolant level. It is normal to see coolant moving in the upper coolant hose return line when the engine is running. Check to see if coolant ...

Other materials:

Hood Ajar Indicator Description and Operation
Hood Ajar Switch The body control module (BCM) applies B+ to the hood ajar signal circuit and monitors the voltage to determine the position of the hood. When the hood is closed, the switch is open and voltage remains high. When the hood is open, the switch is closed and the voltag ...

Exhaust Manifold Heat Shield Installation
Install the exhaust manifold heat shield (2). Caution: Refer to Fastener Caution. Install the 3 exhaust manifold heat shield bolts (1) and the washers and tighten to  8 Y (71 lb in). ...

Ignition and Start Switch Replacement
Ignition and Start Switch Replacement Callout Component Name Preliminary Procedures Disconnect the battery negative cable. Refer to Battery Negative Cable Disconnection and Connection. Remove the ignition and start switch ...

© 2014-2020 Copyright www.csmans.com
   
0.0168