Turn Signal Multifunction Switch Replacement
DoorsFog Lamps (RS)
To replace the front fog lamp bulb:
1. Locate the fog lamp located under the front fascia.
2. Remove the cap from the back of the fog lamp assembly.
3. Disconnect the electrical connector from the fog lamp bulb assembly.
4. Remove the bulb by turning it counterclockwise and pulling it straight ...
Window Motor Programming - Express Function
Window Motor Normalized Procedure
A window motor that has not been normalized will no longer perform the express
up and express down functions, this may occur during the following conditions:
When a window motor has been disconnected
When a door harness has been disconnected
...
Rear Seat Back Cushion Removal and Installation (40%)
Rear Seat Back Cushion Removal and Installation
Callout
Component Name
Preliminary Procedure
Remove the rear seat cushion. Refer to Rear Seat Cushion Removal
and Installation.
Remove the rear seat back cushion bolster. Re ...