GeneralCleaning High Gloss Surfaces and Vehicle Information and Radio Displays
For vehicles with high gloss surfaces or vehicle displays, use a microfiber cloth
to wipe surfaces. Before wiping the surface with the microfiber cloth, use a soft
bristle brush to remove dirt that could scratch the surface. Then use the microfiber
cloth by gently rubbing to clean. Never use w ...
Hood Ajar Indicator Description and Operation
Hood Ajar Switch
The body control module (BCM) applies B+ to the hood ajar signal circuit
and monitors the voltage to determine the position of the hood. When the hood
is closed, the switch is open and voltage remains high. When the hood is open,
the switch is closed and the voltag ...
Vehicle Yaw Sensor Learn
The yaw sensor does not require calibration often. Calibration of the yaw rate
sensor might be required after certain service procedures are performed. Some of
these procedures are as follows:
Electronic brake control module (EBCM) replacement
Multi-axis acceleration sensor replacement
...