|
Callout |
Component Name |
|---|---|
|
Preliminary Procedure
Disconnect the exhaust system hangers in the rear and allow the exhaust system to rest on the rear axle. |
|
|
1 |
Exhaust Heat Shield Rear Muffler Fastener (Qty: 3) |
|
2 |
Exhaust Heat Shield Rear Muffler |
Exhaust Front Pipe Replacement (LUV,LUW)
Exhaust Rear Muffler Replacement (LUV,LUW)Brake Fluid
The brake/clutch master cylinder reservoir is filled with DOT 3 brake fluid as
indicated on the reservoir cap. See Engine Compartment Overview for
the location of the reservoir.
There are only two reasons why the fluid level in the reservoir might go down:
The fluid level goes down ...
Park Brake and P (Park) Mechanism Check
Warning
When you are doing this check, the vehicle could begin to move. You or others
could be injured and property could be damaged. Make sure there is room in front
of the vehicle in case it begins to roll. Be ready to apply the regular brake at
once should the vehicle begin to move.
Park ...
Vehicle Yaw Sensor Learn
The yaw sensor does not require calibration often. Calibration of the yaw rate
sensor might be required after certain service procedures are performed. Some of
these procedures are as follows:
Electronic brake control module (EBCM) replacement
Multi-axis acceleration sensor replacement
...