Chevrolet Sonic Repair Manual: Heater Core Inlet Tube Replacement
|
Callout |
Component Name |
|---|---|
Preliminary Procedures
|
|
|
1 |
Heater Core Tube Cover Bolt (Qty: 2) Caution: Refer to Fastener Caution. |
|
2 |
Heater Core Tube Cover |
|
3 |
Heater Core Tube Clamp (Qty: 2) |
|
4 |
Heater Core Tube Rear Cover Bolt |
|
5 |
Heater Core Tube Rear Cover |
|
6 |
Heater Core Tube Note: Heater Core tubes are serviced as a kit . |
Heating
...
Heater Core Outlet Tube Replacement
Heater Core Outlet Tube Replacement
Callout
Component Name
Preliminary Procedures
Remove the Heater and Air Conditioning Evaporator ...
Other materials:
Emblem/Nameplate Replacement
Caution: Refer to Exterior Trim Emblem Removal Caution.
The part and vehicle surface should be 21?°C (70?°F) prior to installation.
The vehicle should remain inside in a temperature range of 21?°C (70?°F) for
1 hour after assembly to allow the adhesive to develop sufficient bo ...
Engine Replacement (Automatic Transmission)
Special Tools
J-45859 Wheel Drive Shaft Remover
CH-807 Closure Plugs
For equivalent regional tools, refer to Special Tools.
Removal Procedure
Remove the battery and battery tray. Refer to
Battery Tray Replacement.
Relieve the fuel system pressure. Refer to
Fuel Pre ...
System maintenance
Example
Basic information
The two radar sensors A for the I-BSI system are located near the rear bumper.
Always keep the area near the radar sensors clean.
The radar sensors may be blocked by temporary ambient conditions such as snow,
splashing water, mist or fog.
The blocked condition ma ...
0.0054