|
Callout |
Component Name |
|---|---|
Preliminary Procedures
|
|
|
1 |
Heater Core Tube Cover Bolt (Qty: 2) Caution: Refer to Fastener Caution. |
|
2 |
Heater Core Tube Cover |
|
3 |
Heater Core Tube Clamp (Qty: 2) |
|
4 |
Heater Core Tube Rear Cover Bolt |
|
5 |
Heater Core Tube Rear Cover |
|
6 |
Heater Core Tube Note: Heater Core tubes are serviced as a kit . |
Heater Core Inlet Tube Replacement
Heater Core ReplacementInstrument Panel Center Molding Replacement (With U58)
Instrument Panel Center Molding Replacement
Callout
Component Name
1
Instrument Panel Center Molding Assembly
Procedure
Use a flat bladed plastic trim tool in the shown locations, then
rotate the trim tool 90 ...
Center Pillar Lower Trim Panel Replacement
Center Pillar Lower Trim Panel Replacement
Callout
Component Name
Preliminary Procedure
Remove the front side door opening floor carpet retainer. Refer
to Front Side Door Opening Floor Carpet Retainer Replacement.
Remove ...
Ignition Coil Replacement
Special Tools
EN-6009 Remover and Installer Ignition Coil
For equivalent regional tools, refer to Special Tools.
Removal Procedure
Remove the engine wiring harness guide (1) from the
cylinder head.
Disconnect the ignition coil electrical connector (2).
...