Chevrolet Sonic Repair Manual: Indicator/Warning Message Description and Operation
- Indicator LIGHT ON
-
Refer to the owner's manual for the descriptions and explanations of all indicator lights.
For diagnosis and repair information related to an indicator light, refer to the System Diagnosis and the Description of Operation that the message relates to.
- Message Displayed
-
Refer to the owner's manual for descriptions and explanations of all messages displayed.
For diagnosis and repair information related to a displayed message, refer to the System Diagnosis and the Description of Operation that the message relates to.
- CHANGE TIMING BELT MESSAGE
-
The Instrument Cluster monitors the odometer mileage to determine when timing belt (if equipped) replacement may be necessary. After the vehicle has accumulated approximately 100,000 miles (160,000 kilometers), the Instrument Cluster may display the CHANGE TIMING BELT message. After the engine timing belt has been replaced, reset the CHANGE TIMING BELT message by locating and removing the fuses that supply power to the Instrument Cluster for two minutes.
Hood Ajar Indicator Description and Operation
Hood Ajar Switch
The body control module (BCM) applies B+ to the hood ajar signal circuit
and monitors the voltage to determine the position of the hood. When the hood
is closed, the sw ...
Parking Brake Indicator Switch Replacement
Removal Procedure
Remove the front floor console. Refer to
Front Floor Console Replacement.
Ensure that the park brake lever is in the fully released
position.
Disconnect t ...
Other materials:
Parking/Turn Signal Lamp
1. Open the hood. See Hood.
2. Remove the parking/turn signal lamp bulb socket from the headlamp assembly
by turning counterclockwise.
3. Remove the bulb from the bulb socket by pulling it straight out.
4. Install the new bulb in the bulb socket.
5. Install the bulb socket into the headlamp ...
Front Wheel Drive Shaft Seal Replacement - Left Side
Front Wheel Drive Shaft Seal Replacement - Left Side
Callout
Component Name
Preliminary Procedures
Raise and support the vehicle. Refer to Lifting and Jacking the
Vehicle.
Remove the left wheel drive shaft. Refer to Front ...
Intake Manifold Assemble
Install the evaporative emission canister purge solenoid valve (3).
Install the 2 manifold absolute pressure sensors (2).
Install the 2 manifold absolute pressure sensor bolts (1) and tighten.
Install the fuel injection fuel rail assembly ...
0.0067