Chevrolet Sonic Repair Manual: Oil Level Indicator and Tube Removal
- Remove the oil dipstick.
- Remove the oil level indicator tube bolt (1).
- Remove the oil level indicator tube (2) and oil level indicator seal.
Note:
If the engine oil level is at the maximum level, oil may emerge while removing the oil dipstick guide tube.
Oil Level Indicator and Tube Installation
Install a NEW oil level indicator tube gasket.
Install the oil level indicator tube (2).
Caution: Refer to Fastener Caution.
Install the oil level indicator tube bolt&# ...
Oil Lines
...
Other materials:
Steering Angle Sensor Centering
The steering angle sensor does not require centering often. Centering of the
steering angle sensor might be required after certain service procedures are performed.
Some of these procedures are as follows:
Wheel alignment
Steering gear replacement
Steering column replacement
Collision ...
Valve Stem Oil Seal and Valve Spring Replacement
Special Tools
207649 Rod Hairpin Clips
547324 Flange Screws
EN-840 Pliers / Remover
EN-958 Installer
EN-45059 Angle Meter
EN-50717 Kit
J-43649?E Rods
For equivalent regional tools, refer to Special Tools.
Removal Procedure
Remove the spark plugs. Refer to Spark ...
Input and Output Speed Sensor Installation
Input and Output Speed Sensor Installation
Callout
Component Name
1
Input Speed Sensor Assembly Seals
2
Input Speed Sensor Assembly
3
Input Speed Sensor Bolt ...
0.0056