|
Callout |
Component Name |
|---|---|
|
Preliminary Procedure
Remove the sterring wheel inflatable restraint module. Refer to Airbag Steering Wheel Module Replacement. |
|
|
1 |
Steering Wheel Lower Cover |
|
2 |
Steering Wheel Lower Cover Fastener (Qty: 2) |
|
3 |
Radio and Telephone Control Switch Assembly Procedure
Disconnect the electrical connector. |
Radio Windshield Side Garnish Molding Speaker Replacement
Radio/Audio System Description and OperationTire and Wheel Assembly Runout Measurement - On-Vehicle
Raise and support the vehicle.
Closely inspect each tire for proper and even bead seating.
If any of the tire beads were not properly or evenly seated, reseat the
tire bead, then proceed to step 4. Refer to Tire and Wheel Removal and Installation.
Wrap the circumferenc ...
Tire and Wheel Balancing (Collet Cone Selection)
Important: Never use the hub cap bore to center the wheel onto
the balancer. The pilot bore (on the hub side of the wheel) is machined
to be concentric to very tight non - standard tolerances. The bottom cap
bore is not machined to this same degree of precision.
Accurate mac ...
Input Speed Sensor Replacement
Removal Procedure
Remove the control solenoid valve and transmission
control module assembly. Refer to Control Solenoid
Valve and Transmission Control Module Assembly Replacement.
Remove the input speed sensor bolt (2) M6 x 23.
Unlock t ...