Chevrolet Sonic Owner's Manual: Safety Belt Pretensioners
This vehicle has safety belt pretensioners for front outboard occupants. Although the safety belt pretensioners cannot be seen, they are part of the safety belt assembly. They can help tighten the safety belts during the early stages of a moderate to severe frontal, near frontal, or rear crash if the threshold conditions for pretensioner activation are met. And, if the vehicle has side-impact airbags, safety belt pretensioners can help tighten the safety belts in a side crash or a rollover event.
Pretensioners work only once. If the pretensioners activate in a crash, the pretensioners and probably other new parts of the vehicle's safety belt system will need to be replaced. See Replacing Safety Belt System Parts after a Crash.
Shoulder Belt Height Adjuster
The vehicle has a shoulder belt height adjuster for the driver and right front
passenger seating positions.
Adjust the height so the shoulder portion of the belt is on the shoulder and
not fallin ...
Rear Safety Belt Comfort Guides
Rear safety belt comfort guides may provide added safety belt comfort for older
children who have outgrown booster seats and for some adults. When installed on
a shoulder belt, the comfort guide p ...
Other materials:
Tire and Wheel Assembly Balancing - Off Vehicle
Warning: Failure to adhere to the following precautions before tire
balancing can result in personal injury or damage to components:
Clean away any dirt or deposits from the inside of the wheels.
Remove any stones from the tread.
Wear eye protection.
Use coated weights on alum ...
Exhaust Camshaft Replacement
Removal Procedure
Remove the camshaft intake and exhaust sprocket. Refer to Camshaft Intake
and Exhaust Sprocket Replacement.
Remove and DISCARD the camshaft sprocket bolts (2) and the camshaft
position exciter wheels (1).
Allow the both camshaft ...
Throttle Body Assembly Installation
Install a NEW throttle body seal.
Install the throttle body (1).
Caution: Refer to Fastener Caution.
Install the 4 throttle body bolts (2) and tighten to
8 Y (71 lb in).
...
0.0056