Chevrolet Sonic Owner's Manual: Seats and Restraints
- Head Restraints
- Front Seats
- Rear Seats
- Safety Belts
- Why Safety Belts Work
- Questions and Answers About Safety Belts
- How to Wear Safety Belts Properly
- Lap-Shoulder Belt
- Safety Belt Use During Pregnancy
- Safety Belt Extender
- Safety System Check
- Safety Belt Care
- Replacing Safety Belt System Parts after a Crash
- Airbag System
- Airbag System
- Where Are the Airbags?
- When Should an Airbag Inflate?
- What Makes an Airbag Inflate?
- How Does an Airbag Restrain?
- What Will You See after an Airbag Inflates?
- Passenger Sensing System
- Servicing the Airbag-Equipped Vehicle
- Adding Equipment to the Airbag-Equipped Vehicle
- Airbag System Check
- Replacing Airbag System Parts after a Crash
- Child Restraints
Roof
Sunroof
On vehicles with this feature, the sunroof only operates when the ignition is
turned to ON/RUN or Retained Accessory Power (RAP) is active.
Open/Close: To open the sunroof, press and hol ...
Head Restraints
Warning
With head restraints that are not installed and adjusted properly, there is
a greater chance that occupants will suffer a neck/ spinal injury in a crash. Do
not drive until the head restr ...
Other materials:
Fog Lamp Aiming
Preparation Procedure
Note: Horizontal aim is not adjustable on this vehicle. Vertical
aim is done by an adjusting nut located on the rear of the fog lamp. Prior
to aiming the fog lamps, perform the following steps:
Completely assemble all of the components on the vehi ...
Brake Pedal Pushrod Inspection
Disconnect the brake pedal pushrod (2) from the brake pedal.
Reposition the pedal pushrod boot (1) toward the front of the vehicle to
expose as much of the pedal pushrod (2) as possible.
Inspect the brake pedal pushrod (2) for straightness.
If the brake p ...
Aluminum Wheel Refinishing
Finish Damage Evaluation Procedure
Note:
If the wheels are chrome-plated, do not re-plate or refinish
the wheels.
If the wheels are polished aluminum, do not refinish the wheels
in the dealer environment. Utilize a refinisher that meets manufacturer
...
0.0082