Warning:
When carrying an undeployed inflatable restraint seat belt retractor pretensioner:
Failure to observe these guidelines may result in personal injury.
Replacing Safety Belt System Parts after a Crash
Seat Belt Latch Stop InstallationSteering Linkage Outer Tie Rod Inspection
Special Tools
GE-8001 Dial Indicator Set
For equivalent regional tools, refer to Special Tools.
Note: This inspection procedure does not supersede local government
required inspections that have more stringent requirements.
Inspect the outer tie rod seal. If the outer tie rod ...
Tire and Wheel Balancing (Collet Cone Selection)
Important: Never use the hub cap bore to center the wheel onto
the balancer. The pilot bore (on the hub side of the wheel) is machined
to be concentric to very tight non - standard tolerances. The bottom cap
bore is not machined to this same degree of precision.
Accurate mac ...
Clutch Actuator Cylinder Front Pipe Replacement
Removal Procedure
Remove the battery tray. Refer to Battery Tray Replacement.
Remove as much brake fluid out of brake fluid reservoir as possible.
Unclip the clutch actuator cylinder front pipe from the 2 retainers (1).
Remove the retaining ...