Chevrolet Sonic manuals

Chevrolet Sonic Owner's Manual: Turning the System On or Off

the system on and off. /VOL (Power/Volume): Press to turn
the system on and off.

Automatic Switch-Off

If the infotainment system is on after the ignition is turned off, the system will turn off automatically after 10 minutes.

Volume Control

the volume. /VOL (Power/Volume): Turn to adjust
the volume.

OnStar, press and hold  to mute the (Phone/Mute): For vehicles with
OnStar, press and hold infotainment system. Press and hold to mute the
infotainment system. Press and hold again, or turn the O /VOL knob to cancel mute. For vehicles without OnStar, press
again, or turn the O /VOL knob to cancel mute. For vehicles without OnStar, press again, or turn the to mute the infotainment system. Press
/VOL knob to cancel mute. again, or turn the
Menu System /VOL knob to cancel mute.


Radio Controls without Touchscreen
The infotainment system is operated by using the pushbuttons, multifunction knobs, menus shown on the display, and steering wheel controls, if equipped. ...

Menu System
Controls The Push/MENU/TUNE knob, Push/ MENU/TUNE button, and / BACK button are used to navigate the menu system. Push/MENU/TUNE Knob: Turn to: Enter the menu system. Highlight a menu optio ...

Other materials:

Dimensions - Body (4NB)
Point-to-point measurements are for reference only. All measurements are given in millimeters. Use these measurements for diagnosing and estimating. Point-to-point measurements are duplicated with tram bar pointers set at equal lengths. All die marks, holes, slots, and fasteners are measured t ...

Tire and Wheel Assembly Runout Measurement - On-Vehicle
Raise and support the vehicle. Closely inspect each tire for proper and even bead seating. If any of the tire beads were not properly or evenly seated, reseat the tire bead, then proceed to step 4. Refer to Tire and Wheel Removal and Installation. Wrap the circumferenc ...

Engine Front Cover and Oil Pump Disassemble
Engine Front Cover Disassemble Remove the intake camshaft position sensor bolt (1). Remove the intake camshaft position sensor (2) and the seal ring (3). Remove the exhaust camshaft position sensor bolt (6). Remove the exhaust camshaft posi ...

В© 2014-2025 Copyright www.csmans.com
 
0.006