The common hydraulic clutch and brake master cylinder fluid reservoir is filled with DOT 3 brake fluid as indicated on the reservoir cap. See Engine Compartment Overview for reservoir location.
Hydraulic Clutch
How to Check and Add FluidCrankshaft Balancer Installation
Special Tools
EN-470–B Angular Torque Wrench
EN-956?E Extension
EN-49979 Crankshaft Shock Mount Retainer
For equivalent regional tools, refer to Special Tools.
Note: The crankshaft balancer flange must fit to the hexagon of
the oil pump rotor (2) and to the two ...
Timing Chain Tensioner Replacement
Timing Chain Tensioner Replacement
Callout
Component Name
Preliminary Procedure
Remove the camshaft timing chain . Refer to Camshaft Timing Chain Replacement.
1
Timing Chain Tensioner Fastener (Q ...
Thrust Washer and Bearing Cleaning and Inspection
Warning: Wear safety glasses to avoid injury when using compressed
air or any cleaning solvent. Bodily injury may occur if fumes are inhaled
or if skin is exposed to chemicals.
Caution: Do not allow the bearings to spin. Turn them slowly by
hand. Spinning the beari ...