Chevrolet Sonic Owner's Manual: Air Vents

Chevrolet Sonic Owner's Manual / Climate Controls / Air Vents

Use the air vents located in the center and on the side of the instrument panel to direct the airflow. Move the slats on the center air vents to direct airflow.

Turn the knobs on the side air vents counterclockwise or clockwise to open or close off the airflow.

Operation Tips

Clear away any ice, snow, or leaves from the air inlets at the base of the windshield that may block the flow of air into the vehicle.
Use of non-GM approved hood deflectors may adversely affect the performance of the system.
Keep the path under the front seats clear of objects to help circulate the air inside the vehicle more effectively.

Rear Window and Outside Mirror Defogger

(Rear Window Defogger): Press to turn the rear window and outside mirror defogger on or off. An indicator light comes on to show that the feature is on. The rear window defogger turns off after ...

Maintenance

Air Intake Clear away any ice, snow, or leaves from the air intake at the base of the windshield that can block the flow of air into the vehicle. Passenger Compartment Air Filter The filter remov ...

Other materials:

Turn and Lane-Change Signals
Move the lever all the way up or down to signal a turn. An arrow on the instrument cluster will flash in the direction of the turn or lane change. Raise or lower the lever until the arrow starts to flash to signal a lane change. Hold it there until the lane change is completed. If the lever ...

Fog Lamp Aiming
Preparation Procedure Note: Horizontal aim is not adjustable on this vehicle. Vertical aim is done by an adjusting nut located on the rear of the fog lamp. Prior to aiming the fog lamps, perform the following steps: Completely assemble all of the components on the vehi ...

Tire and Wheel Balancing (Collet Cone Selection)
Important: Never use the hub cap bore to center the wheel onto the balancer. The pilot bore (on the hub side of the wheel) is machined to be concentric to very tight non - standard tolerances. The bottom cap bore is not machined to this same degree of precision. Accurate mac ...

0.0055