Headlamp Aiming
Bulb ReplacementSunroof Window Seal Replacement
Removal Procedure
Remove the sunroof window panel. Refer to Sunroof Window Replacement.
Remove the seal from the window panel frame by pulling the seal away
at one point and continuing around the perimeter of the frame.
Clean around the edge of the inside surf ...
Tire and Wheel Assembly Runout Measurement - On-Vehicle
Raise and support the vehicle.
Closely inspect each tire for proper and even bead seating.
If any of the tire beads were not properly or evenly seated, reseat the
tire bead, then proceed to step 4. Refer to Tire and Wheel Removal and Installation.
Wrap the circumferenc ...
System maintenance
Example
Basic information
The two radar sensors A for the I-BSI system are located near the rear bumper.
Always keep the area near the radar sensors clean.
The radar sensors may be blocked by temporary ambient conditions such as snow,
splashing water, mist or fog.
The blocked condition ma ...