Chevrolet Sonic Owner's Manual: Cleaning High Gloss Surfaces and Vehicle Information and Radio Displays
For vehicles with high gloss surfaces or vehicle displays, use a microfiber cloth to wipe surfaces. Before wiping the surface with the microfiber cloth, use a soft bristle brush to remove dirt that could scratch the surface. Then use the microfiber cloth by gently rubbing to clean. Never use window cleaners or solvents. Periodically hand wash the microfiber cloth separately, using mild soap. Do not use bleach or fabric softener. Rinse thoroughly and air dry before next use.
Caution
Do not attach a device with a suction cup to the display. This may cause damage and would not be covered by the warranty.
Fabric/Carpet/Suede
Start by vacuuming the surface using a soft brush attachment. If a rotating brush
attachment is being used during vacuuming, only use it on the floor carpet. Before
cleaning, gently remove as much ...
Instrument Panel, Leather, Vinyl, Other Plastic Surfaces, Low Gloss Paint Surfaces
and Natural Open Pore Wood Surfaces
Use a soft microfiber cloth dampened with water to remove dust and loose dirt.
For a more thorough cleaning, use a soft microfiber cloth dampened with a mild soap
solution.
Caution
Soaking or sa ...
Other materials:
Forward Collision Alert (FCA) Warning Light
These lights are on the center of the instrument panel.
The vehicle ahead light comes on when a vehicle is detected ahead and a possible
collision can occur.
The forward collision alert comes on when following a vehicle much too closely.
The light flashes when a vehicle is being rapidly ap ...
Driver or Passenger Seat Cushion Heater Replacement
Driver or Passenger Seat Cushion Heater Replacement
Callout
Component Name
Warning: Refer to SIR Warning.
Preliminary Procedures
Remove the driver or passenger seat. Refer to Driver or Passenger
Seat Removal a ...
Wheel Drive Shaft Inner Joint Inspection
Inspection Procedure
Remove the front wheel drive shaft inner joint and boot. Refer to Front
Wheel Drive Shaft Replacement.
Remove the wheel drive shaft tripod bushing (1) from the tripod housing (3).
Remove the wheel drive shaft tripod housi ...
0.006