Chevrolet Sonic manuals

Chevrolet Sonic Owner's Manual: Instrument Panel, Leather, Vinyl, Other Plastic Surfaces, Low Gloss Paint Surfaces and Natural Open Pore Wood Surfaces

Chevrolet Sonic Owner's Manual / Vehicle Care / Appearance Care / Interior Care / Instrument Panel, Leather, Vinyl, Other Plastic Surfaces, Low Gloss Paint Surfaces and Natural Open Pore Wood Surfaces

Use a soft microfiber cloth dampened with water to remove dust and loose dirt. For a more thorough cleaning, use a soft microfiber cloth dampened with a mild soap solution.

Caution

Soaking or saturating leather, especially perforated leather, as well as other interior surfaces, may cause permanent damage. Wipe excess moisture from these surfaces after cleaning and allow them to dry naturally. Never use heat, steam, spot lifters, or spot removers. Do not use cleaners that contain silicone or wax-based products. Cleaners containing these solvents can permanently change the appearance and feel of leather or soft trim and are not recommended.

Do not use cleaners that increase gloss, especially on the instrument panel. Reflected glare can decrease visibility through the windshield under certain conditions.

Caution

Use of air fresheners may cause permanent damage to plastics and painted surfaces. If an air freshener comes in contact with any plastic or painted surface in the vehicle, blot immediately and clean with a soft cloth dampened with a mild soap solution. Damage caused by air fresheners would not be covered by the vehicle warranty.

Cleaning High Gloss Surfaces and Vehicle Information and Radio Displays
For vehicles with high gloss surfaces or vehicle displays, use a microfiber cloth to wipe surfaces. Before wiping the surface with the microfiber cloth, use a soft bristle brush to remove dirt tha ...

Cargo Cover and Convenience Net
Wash with warm water and mild detergent. Do not use chlorine bleach. Rinse with cold water, and then dry completely. ...

Other materials:

Camshaft Cover Replacement
Camshaft Cover Replacement Callout Component Name Preliminary Procedures Remove the ignition coil. Refer to Ignition Coil Replacement. Remove the PCV hose. Refer to Positive Crankcase Ventilation Hose/Pipe/Tube Replac ...

Control Valve Channel Plate Cleaning and Inspection (6T30/40/45/50 - Gen 2)
34 Control Valve Channel Plate Cleaning and Inspection Callout Component Name 1 Control Valve Body Spacer Plate Retainer 2 Channel Plate to Valve Body Spacer Plate Assembly 3 ...

Manual Transmission Shift Lever and Selector Lever Cable Adjustment
Remove the floor console. Refer to Front Floor Console Replacement. Lift upward and disengage (do not remove) both cable lock adjusters (1) to release the internal cable assembly, one for each side. Block the shift control housing, push the selector lever ( ...

В© 2014-2025 Copyright www.csmans.com
 
0.0088