Wash with warm water and mild detergent. Do not use chlorine bleach. Rinse with cold water, and then dry completely.
Instrument Panel, Leather, Vinyl, Other Plastic Surfaces, Low Gloss Paint Surfaces
and Natural Open Pore Wood Surfaces
Care of Safety BeltsHeadlamp Aiming
Visual Aiming Preparation Procedure
Note: Some state and local laws specify requirements for headlamp
aim. Comply with all of these laws when performing any headlamp aiming operations.
Headlamp aim should be checked:
When a new headlamp capsule is installed.
If ser ...
Emblem/Nameplate Replacement
Caution: Refer to Exterior Trim Emblem Removal Caution.
The part and vehicle surface should be 21?°C (70?°F) prior to installation.
The vehicle should remain inside in a temperature range of 21?°C (70?°F) for
1 hour after assembly to allow the adhesive to develop sufficient bo ...
Heater and Air Conditioning Evaporator and Blower Module Removal and Installation
Heater and Air Conditioning Evaporator and Blower Module Removal and
Installation
Callout
Component Name
Preliminary Procedures
Recover the refrigerant. Refer to Refrigerant Recovery and Recharging.
Drain the cooling sy ...