Chevrolet Sonic Owner's Manual: Delayed Locking
This feature delays the actual locking of the doors until five seconds after all doors are closed. Delayed locking can only be turned on when the Unlocked Door Anti Lockout feature has been turned off.
When 
is pressed on the driver or
passenger door power lock switch while the door is open, a chime will sound three
times to indicate that delayed locking is active. The doors will then lock automatically
five seconds after all doors are closed.
If a door is reopened before five seconds have elapsed, the five second timer
will reset once all the doors are closed again. Press
on the door lock switch again, or press
on the RKE transmitter, to override
this feature and lock the doors immediately.
Delayed locking can be programmed through the Driver Information Center (DIC). See Vehicle Personalization.
Door Ajar Reminder
If one of the doors, the trunk, or the liftgate is not closed properly while
the ignition is on, the door ajar light on the instrument panel comes on and stays
on until the doors are closed. ...
Automatic Door Locks
The vehicle is programmed so that when the doors are closed, the ignition is
on, and the shift lever is moved out of P (Park) for automatic transmissions, or
when the vehicle speed is above 13 km/ ...
Other materials:
Lane Departure Warning (LDW) Light
This light comes on briefly while starting the vehicle. If it does not, have
the vehicle serviced by your dealer. If the system is working normally, the light
then turns off.
This light comes on green when the system is on and ready to operate. When the
system determines that the vehicle is ...
Positive Crankcase Ventilation Hose/Pipe/Tube Replacement
Removal Procedure
Remove the air cleaner outlet duct. Refer to Air Cleaner Outlet Duct
Replacement.
Open the 2 positive crankcase ventilation pipe retainer clips (2) and (3).
Note: Move retainer clamp (1) in direction of the arrow. ...
Engine Block Cleaning and Inspection
Special Tools
EN-8087 Cylinder Gauge
For equivalent regional tools, refer to Special Tools.
Clean the sealing material from the gasket mating surfaces (2).
Clean the engine block (1) and lower crankcase in a cleaning tank with solvent
appropriate for aluminum. Refer ...
0.0058