Chevrolet Sonic Repair Manual: Door Lock and Ignition Lock Folding and Non-Folding Key Cutting
High Security keys are available from the service parts system.
Obtain the key code from the security card or from the GM Dealer World, Parts, Key Code Look Up system.
If you have the key code and access to a Triax-E., BD Laser or other code key cutting machine from the GM Dealer Equipment Catalog, you may cut a new key.
If you have the original key and access to a Matrix S, BD Laser or other key duplicating machine, you may duplicate the key.
If you do not have a high security key cutting machine, order the side cut key from the service parts system. Include the key code in the NOTE field. Indicate the timing and the method of the shipment.
Inspect the new key operation in the lock cylinder. Ensure the new key operates effectively.
Keyless Entry System Description and Operation
The keyless entry system is a vehicle entry device. The keyless entry system
is used in conjunction with the door locks to unlock the vehicle. Keyless entry
will lock/unlock the vehicle doors or o ...
Other materials:
Center Pillar Reinforcement Replacement
Removal Procedure
Warning: Refer to Approved Equipment for Collision Repair
Warning.
Warning: Refer to Glass and Sheet Metal Handling Warning.
Note: The center pillar upper stiffener is made of Dual Phase
Steel and should be replaced only at ...
Tire and Wheel Balancing (Collet Cone Selection)
Important: Never use the hub cap bore to center the wheel onto
the balancer. The pilot bore (on the hub side of the wheel) is machined
to be concentric to very tight non - standard tolerances. The bottom cap
bore is not machined to this same degree of precision.
Accurate mac ...
Camshaft Seal Replacement
Special Tools
EN 422 Installer
EN 45000 Remover
For equivalent regional tools, refer to Special Tools
Removal Procedure
Remove the intake and exhaust camshaft sprocket. Refer to Camshaft Sprocket
Replacement.
Note: Do not damage the sealing surfaces.
...
0.0051