Callout |
Component Name |
---|---|
Preliminary Procedures
Drain the cooling system. Refer to Cooling System Draining and Filling. |
|
1 |
Retaining Clamp |
2 |
Engine Coolant Temperature Sensor Procedure
Disconnect the electrical connector. |
Use of Room Temperature Vulcanizing (RTV) and Anaerobic Sealant
Pipe Joint Compound
Note: Three types of sealer are commonly used in engines. These
are RTV sealer, anaerobic gasket eliminator sealer, and pipe joint compound.
The correct sealer and amount must be used in the proper location to prevent
oil leaks. DO NOT interchange the 3 ...
Valve Stem Oil Seal and Valve Spring Replacement
Special Tools
207649 Rod Hairpin Clips
547324 Flange Screws
EN-840 Pliers / Remover
EN-958 Installer
EN-45059 Angle Meter
EN-50717 Kit
J-43649?E Rods
For equivalent regional tools, refer to Special Tools.
Removal Procedure
Remove the spark plugs. Refer to Spark ...
Transmission Replacement
Removal Procedure
Remove the battery and battery tray. Refer to
Battery Tray Replacement.
Disconnect the transmission range selector lever cable
terminal (1) from the transmission manual pin.
Press the locking tab forward in order to release
the tran ...