Chevrolet Sonic Owner's Manual: Filling a Portable Fuel Container
Warning
Filling a portable fuel container while it is in the vehicle can cause fuel vapors that can ignite either by static electricity or other means. You or others could be badly burned and the vehicle could be damaged. Always:
- . Use approved fuel containers.
- . Remove the container from the vehicle, trunk, or pickup bed before filling.
- . Place the container on the ground.
- . Place the nozzle inside the fill opening of the container before dispensing fuel, and keep it in contact with the fill opening until filling is complete.
- . Fill the container no more than 95% full to allow for expansion.
- . Do not smoke, light matches, or use lighters while pumping fuel.
- . Avoid using cell phones or other electronic devices.
Filling the Tank
Warning
Fuel vapors and fuel fires burn violently and can cause injury or death.
. To help avoid injuries to you and others, read and follow all the instructions
on the fuel pump island.
. T ...
Trailer Towing
General Towing Information
The vehicle is neither designed nor intended to tow a trailer. ...
Other materials:
Rear Window Replacement
Special Tools
BO-24402-A Glass Sealant Remover (Cold Knife)
BO-39032 Stationary Glass Removal Tool
Use an adhesive that is approved by GM
For equivalent regional tools, refer to Special Tools
Removal Procedure
Warning: If a window is cracked but still intact, crisscros ...
Oil Pan Installation
Special Tools
EN-49980 Guidance Pins
For equivalent regional tools, refer to Special Tools.
Clean the sealing surfaces from old sealing material, dirt, oil and grease.
Note: The sealing bead should be applied close to the inner edge
of the oil pan. Take care that the oil suctio ...
Camshaft Timing Chain Installation
Special Tools
EN-952 Fixing Pin
EN-953-A Fixing Tool
EN-955-10 Fixing Pin from EN-955 Kit
For equivalent regional tools, refer to Special Tools.
The engine should be adjusted to TDC.
The crankshaft should be locked with EN-952 fixing pin.
The camshaft should be locked with EN-9 ...
0.0054