To flash the high beams, pull the turn signal lever all the way toward you. Then release it.
Fog Lamp Aiming
Preparation Procedure
Note: Horizontal aim is not adjustable on this vehicle. Vertical
aim is done by an adjusting nut located on the rear of the fog lamp. Prior
to aiming the fog lamps, perform the following steps:
Completely assemble all of the components on the vehi ...
Wheel Drive Shaft Inner Joint Inspection
Inspection Procedure
Remove the front wheel drive shaft inner joint and boot. Refer to Front
Wheel Drive Shaft Replacement.
Remove the wheel drive shaft tripod bushing (1) from the tripod housing (3).
Remove the wheel drive shaft tripod housi ...
Secondary Air Injection Pump Installation
Install the secondary air injection pump (1).
Loosely install the secondary air injection pump nut (2) and the 2 secondary
air injection pump bolts (4).
Caution: Refer to Fastener Caution.
Tighten the secondary air injection pump nut (2) an ...