Chevrolet Sonic manuals

Chevrolet Sonic Repair Manual: Front Side Door Upper Hinge and Lower Hinge Replacement

Chevrolet Sonic Repair Manual / Body / Doors and Enclosures / Doors / Front Side Door Upper Hinge and Lower Hinge Replacement



Front Side Door Upper Hinge and Lower Hinge Replacement

Callout

Component Name

1

Front Side Door Upper Hinge to Body Bolt (Qty:?€‰2)

Caution:

Refer to Fastener Caution.

Procedures

  1. Before removing the door, apply a double layer of masking tape around the perimeter of the painted surfaces.
  2. Mark the location of the hinge being removed.
  3. Remove the front wheelhouse liner. Refer to Front Wheelhouse Liner Replacement.
  4. Support the door before removing the hinge bolts.
Tighten


32?€‰Y (24?€‰lb?€‰ft)

2

Front Side Door Upper Hinge to Door Bolt (Qty:?€‰2)

Tighten


25?€‰Y (18?€‰lb?€‰ft)

3

Front Side Door Upper Hinge

4

Front Side Door Lower Hinge to Body Bolt (Qty:?€‰2)

Tighten


32?€‰Y (24?€‰lb?€‰ft)

5

Front Side Door Lower Hinge to Door Bolt (Qty:?€‰2)

Tighten


25?€‰Y (18?€‰lb?€‰ft)

6

Front Side Door Lower Hinge

Procedure

If the door striker needs adjust. Refer to Front Side Door Lock Striker Adjustment.

Front Side Door Upper Front Trim Panel Replacement
Front Side Door Upper Front Trim Panel Replacement Callout Component Name 1 Front Side Door Upper Front Trim Panel Assem ...

Front Side Door Weatherstrip Replacement - Body Side
Front Side Door Weatherstrip Replacement - Body Side Callout Component Name Preliminary Procedures Remove the upper center pillar t ...

Other materials:

Lockout Protection
If the driver side power door lock switch is pressed when the driver door is open and the key is in the ignition, all of the doors will lock and then the driver door will unlock. If Unlocked Door Anti Lockout is turned on and: the vehicle is off, the driver door is open, and door locking is r ...

Parking Brake Adjustment (Drum Brake)
Note: The park brake cable adjusting nut is a nylon lock type. Use ONLY HAND TOOLS whenever tightening or loosening the adjusting nut. Apply and fully release the park brake several times. Verify that the park brake lever releases completely. Turn ON the ignition. Verify the red B ...

Reverse (Gen 1)
When the gear selector lever is moved to the Reverse (R) position (from the Park position) the normally-high 35R pressure control solenoid 2 is commanded ON and the following changes occur in the transmission? hydraulic and electrical systems: 3-5-Reverse Clutch Applies Manual Valv ...

© 2014-2024 Copyright www.csmans.com
 
0.0063