Chevrolet Sonic manuals

Chevrolet Sonic Repair Manual: Hood Adjustment



Hood Adjustment

Callout

Component Name

1

Hood

Caution:

Refer to Fastener Caution.

Procedure

  1. Loosen the 4 hood hinge nuts.
  2. Adjust the hood in order to obtain an even gap on both sides between the hood and the fenders, the headlamps and the front bumper fascia and so that the hood is flush with both fenders on the front edge, the front bumper fascia and the headlamps.
Adjustment:

  • Hood to front fender?€‰(a) 3.0?€‰mm?€‰?±?€‰0.75?€‰mm?€‰(0.12?€‰in?€‰?±?€‰0.03?€‰in)
  • Hood to headlamp?€‰(b) 3.0?€‰mm?€‰?±?€‰1.0?€‰mm?€‰(0.12?€‰in?€‰?±?€‰0.04?€‰in)
  • Hood to front bumper fascia?€‰(c) 3.0?€‰mm?€‰?±?€‰1.0?€‰mm?€‰(0.12?€‰in?€‰?±?€‰0.04?€‰in)
Tighten


22?€‰Y (16?€‰lb?€‰ft)

Hood Assembly
...

Hood Hold-Open Device Warning
Warning: When a hood hold open device is being removed or installed, provide alternate support to avoid the possibility of damage to the vehicle or personal injury. ...

Other materials:

Rear Side Door Replacement
Rear Side Door Replacement Callout Component Name Warning: Refer to SIR Warning. Preliminary Procedures Mark the location of the hinge before removing the bolts with a grease pencil. Remove the rear door ...

Rear Compartment Sill Trim Plate Replacement
Rear Compartment Sill Trim Plate Replacement Callout Component Name Preliminary Procedure Partially remove the rear compartment opening weatherstrip. Refer to Rear Compartment Lid Weatherstrip Replacement. ...

Engine Flywheel Installation
Special Tools EN-652 Flywheel Holder EN-45059 Torque Angle Sensor Kit For equivalent regional tools, refer to Special Tools. Clean the thread in the crankshaft. Install the crankshaft position reluctor ring (1). Install the flywheel (2). Install the EN-6 ...

© 2014-2025 Copyright www.csmans.com
 
0.0066