Chevrolet Sonic Repair Manual: Instrument Panel Center Molding Replacement (Without U58)

Chevrolet Sonic Repair Manual / Body / Body Interior / Dashboard Assembly / Instrument Panel Center Molding Replacement (Without U58)

Instrument Panel Center Molding Replacement
Callout	Component Name
1	Instrument Panel Center Molding Assembly Procedure Use a flat bladed plastic trim tool in the shown locations, then rotate the trim tool 90?° to release the top of the molding away from the instrument panel assembly. Grasp the molding with both hands, one on each side of the air outlets, and pull straight back, working from top to bottom. When replacing the center molding assembly, transfer all necessary components.

Instrument Panel Center Molding Replacement (With U58)

Instrument Panel Center Molding Replacement Callout Component Name 1 Instrument Panel Center Molding Assembly Procedu ...

Instrument Panel Center Trim Panel Replacement

Instrument Panel Center Trim Panel Replacement Callout Component Name 1 Instrument Panel Center Trim Panel (Qty:?€‰2 ...

Other materials:

Front Wheel Drive Shaft Inner Joint and Boot Replacement
Special Tools DT-35910 Drive Axle Boot Clamp Pliers For equivalent regional tools, refer to Special Tools. Disassemble Procedure Note: There are types of inner joints available. If the inner joint is connected with the CV style joint, the inner joint is not serviced separa ...

Neutral - Engine Running (Gen 1)
When the gear selector is moved to the Neutral (N) position, the hydraulic and electrical system operation is identical to Park (P) range. However, if Neutral is selected after the vehicle was operating in Reverse (R), the normally-high 35R pressure control solenoid 2 is commanded OFF and the ...

Fluid Passages (Gen 2)
Figure 1: Torque Converter and Differential Housing - Case Side Figure 2: Fluid Pump Body - Fluid Pump Cover Side Figure 3: Fluid Pump Cover - Fluid Pump Body Side Figure 4: Case - Torque Converter and Differential Housing Side Fig ...

0.0058