If equipped, use the window crank to open and close each window. The rear windows do not open fully.
Windows
Power WindowsBackup Lamp Switch Replacement
Removal Procedure
Disconnect the electrical connector from the backup lamp switch?€‰(1).
Remove the backup lamp switch?€‰(1) from the transmission.
Remove and DISCARD the backup lamp switch washer from the backup lamp
switch.
Installation Proc ...
Brake Fluid Level Indicator Switch Replacement
Removal Procedure
Disconnect the brake fluid level indicator switch electrical connector.
Using a small, flat-bladed tool, lift the locking tab on the underside
of the brake fluid level indicator switch (1) and remove the switch.
Inspect the master cyli ...
Tire and Wheel Balancing (Wheel Pilot Bore Greasing)
Beginning with MY 2011 vehicle, pilot bore grease should be applied.
To enable this, grease must be applied to the pilot bore to prevent the
wheel from seizing onto the hub.
Refer to Adhesives, Fluids, Lubricants, and Sealers for pilot bore lubricant
part number.
Do not use any pene ...