Chevrolet Sonic manuals

Chevrolet Sonic Repair Manual: Rear Side Door Upper Hinge and Lower Hinge Replacement

Chevrolet Sonic Repair Manual / Body / Doors and Enclosures / Doors / Rear Side Door Upper Hinge and Lower Hinge Replacement



Rear Side Door Upper Hinge and Lower Hinge Replacement

Callout

Component Name

1

Rear Side Door Upper Hinge to Body Bolts (Qty:?€‰2)

Caution:

Refer to Fastener Caution.

Procedures

  1. Before removing the door, apply a double layer of masking tape around the perimeter of the painted surfaces.
  2. Mark the location of the hinge being removed.
  3. Support the door before removing the hinge bolts.
Tighten


32?€‰Y (24?€‰lb?€‰ft)

2

Rear Side Door Upper Hinge to Door Bolts (Qty:?€‰2)

Tighten


25?€‰Y (18?€‰lb?€‰ft)

3

Rear Side Door Upper Hinge

4

Rear Side Door Lower Hinge to Body Bolts (Qty:?€‰2)

Tighten


32?€‰Y (24?€‰lb?€‰ft)

5

Rear Side Door Lower Hinge to Door Bolts (Qty:?€‰2)

Tighten


25?€‰Y (18?€‰lb?€‰ft)

6

Rear Side Door Lower Hinge

Procedure

If the door striker needs adjust. Refer to Rear Side Door Lock Striker Adjustment.

Rear Side Door Upper Front Auxiliary Weatherstrip Retainer Replacement
Rear Side Door Upper Front Auxiliary Weatherstrip Retainer Replacement Callout Component Name 1 Front Side Door Upper Fr ...

Rear Side Door Upper Rear Trim Panel Replacement (Hatchback)
Rear Side Door Upper Rear Trim Panel Replacement Callout Component Name 1 Rear Side Door Upper Rear Trim Panel Assembly ...

Other materials:

Instrument Panel Fuse Block Access Hole Cover Replacement (With AAL)
Instrument Panel Fuse Block Access Hole Cover Replacement Callout Component Name 1 Instrument Panel Fuse Block Access Hole Cover Procedure Grasp the lower edge of the fuse block cover and pull outward disengaging ...

Windshield Wiper Arm Replacement
Windshield Wiper Arm Replacement Callout Component Name Preliminary Procedure Open and support the hood assembly. 1 Windshield Wiper Arm Nut Cap Tip: Use a small flat-bladed tool in order to ...

Battery Disconnect Warning
Warning: Unless directed otherwise, the ignition and start switch must be in the OFF or LOCK position, and all electrical loads must be OFF before servicing any electrical component. Disconnect the negative battery cable to prevent an electrical spark should a tool or equipment come in c ...

© 2014-2026 Copyright www.csmans.com
 
0.0079