Chevrolet Sonic manuals

Chevrolet Sonic Repair Manual: Rear Side Door Window Regulator Motor Replacement

Chevrolet Sonic Repair Manual / Body / Doors and Enclosures / Doors / Rear Side Door Window Regulator Motor Replacement



Rear Side Door Window Regulator Motor Replacement

Callout

Component Name

Warning:

Refer to Glass and Sheet Metal Handling Warning.

Preliminary Procedure

Remove the rear side door window regulator. Refer to Rear Side Door Window Regulator Replacement.

1

Rear Side Door Window Regulator Motor Screw (Qty:?€‰3).

Caution:

Refer to Fastener Caution.

Procedure

  1. Remove the rear side door water deflector.
  2. Remove the rear side door window from the guide. Do Not remove the window from the vehicle, raise the window to the fully up position, tape in place.
  3. Disconnect the electrical connector from the window regulator motor.
Tighten


5?€‰Y?€‰(44?€‰lb?€‰in)

2

Rear Side Door Window Regulator Motor

Procedure

Inspect the door window for proper operation before installing the door trim panel.

Rear Side Door Window Regulator Handle Replacement
Rear Side Door Window Regulator Handle Replacement Callout Component Name 1 Rear Side Door Window Regulator Handle Clip ...

Rear Side Door Window Regulator Replacement (Hatchback)
Rear Side Door Window Regulator Replacement Callout Component Name Warning: Refer to Glass and Sheet Metal Handling Warning. ...

Other materials:

Parking Brake Adjustment (Disc Brake)
Note: The park brake cable adjusting nut is a nylon lock type. Use ONLY HAND TOOLS whenever tightening or loosening the adjusting nut. Apply and fully release the park brake several times. Verify that the park brake lever releases completely. Turn ON the ignition. Verify the red B ...

Ignition Coil Replacement
Special Tools EN-6009 Remover and Installer Ignition Coil For equivalent regional tools, refer to Special Tools. Removal Procedure Remove the engine wiring harness guide (1) from the cylinder head. Disconnect the ignition coil electrical connector (2). ...

Neutral - Engine Running (Gen 2)
When the gear selector is moved to the Neutral (N) position, the hydraulic and electrical system operation is identical to Park (P) range. However, if Neutral is selected after the vehicle was operating in Reverse (R), the normally-low 35R pressure control solenoid is commanded OFF and the fol ...

© 2014-2024 Copyright www.csmans.com
 
0.0065