Chevrolet Sonic Repair Manual: Remote Control Door Lock Receiver Programming and Setup
- Diagnostic Aids
-
The remote control door lock receiver only functions as an antenna, receiving the signals sent by the keyless entry transmitter and forwarding them to the body control module (BCM). The keyless entry software is contained wholly within the BCM.
- Replace and Program ECU or Reprogram ECU
-
This ECU does not require SPS programming or any setup procedures.
Rear Door Lock Cylinder Replacement
Rear Door Lock Cylinder Replacement
Callout
Component Name
1
Rear Side Door Lock Cylinder Opening Cover Screw Access Plu ...
Remote Control Door Lock Receiver Replacement
Remote Control Door Lock Receiver Replacement
Callout
Component Name
Preliminary Procedure
Remove the windshield outside moistu ...
Other materials:
Tire Pressure Monitor System
The Tire Pressure Monitor System (TPMS) uses radio and sensor technology to check
tire pressure levels. The TPMS sensors monitor the air pressure in your tires and
transmit tire pressure readings to a receiver located in the vehicle.
Each tire, including the spare (if provided), should be check ...
Brake Pedal Position Sensor Replacement
Removal Procedure
Remove the instrument panel lower trim pad cover. Refer to Instrument
Panel Lower Trim Pad Cover Replacement.
Disconnect the brake pedal position sensor electrical connector.
Remove the brake pedal position sensor bolt?€‰(1).
Remove t ...
Engine compartment check locations
Window washer fluid reservoir
Fuse/fusible link holder
Engine oil filler cap
Engine oil dipstick
Brake fluid reservoir
Battery
Engine coolant reservoir
Radiator filler cap
Drive belts
Air cleaner
VR35DDTT engine
NOTE:
Depending on the configuration of your Nissan Arma ...
0.0056