Chevrolet Sonic Repair Manual: Locks
- Door Lock Switch Replacement
- Door Lock and Ignition Lock Folding Key Blade Removal and Installation
- Door Lock and Ignition Lock Folding and Non-Folding Key Cutting
- Rear Door Lock Cylinder Replacement
- Remote Control Door Lock Receiver Programming and Setup
- Remote Control Door Lock Receiver Replacement
- Front Side Door Lock Cylinder Coding (Free Wheeling)
- Front Side Door Lock Cylinder Coding (Non Free Wheeling)
- Front Side Door Lock Cylinder Opening Cover Replacement
- Front Side Door Lock Cylinder Replacement
- Front Side Door Lock Cylinder Rod Replacement
- Lock Cylinder Coding - Ignition
- Rear Compartment Lid Lock Cylinder Coding
- Rear Side Door Lock Cylinder Opening Cover Replacement
Remote Keyless Entry (RKE) System Operation
The RKE transmitter may work up to 60 m (195 ft) away from the vehicle.
Other conditions can affect the performance of the transmitter. See
Remote Keyless Entry (RKE) System.
RK ...
Door Lock Switch Replacement
Door Lock Switch Replacement
Callout
Component Name
Preliminary Procedure
Remove the heater and air conditioning control. Refer ...
Other materials:
Seat Adjustment
Manual Seats
To adjust a manual seat:
1. Pull the handle at the front of the seat.
2. Slide the seat to the desired position and release the handle.
3. Try to move the seat back and forth to be sure it is locked in place.
See Seat Adjustment.
Seat Height Adjuster
If available, move the le ...
Repairing Damaged Wire Insulation
If the wire insulation has been chafed, or broken, enough to show the conductive
portion of the wire, and the wire is not damaged, determine the length of insulation
that needs to be repaired. If the repair is less than 280?€‰mm (11?€‰in), cut the
wire within the damaged area. Then sli ...
Exhaust Manifold Installation
Clean the exhaust manifold sealing surface.
Install a NEW exhaust manifold gasket (1) to the cylinder head.
Caution: Refer to Fastener Caution.
Caution: Refer to Torque-to-Yield Fastener Caution.
Install the exhaust manifold (3) and tighten the NEW nu ...
0.0056