Chevrolet Sonic Repair Manual: Door Lock and Ignition Lock Folding Key Blade Removal and Installation
Special Tools
BO-51098 Flip Key Blade Fixture
For equivalent region tools, refer to Special Tools.
- Insert the RKE transmitter in the fixture as shown.
- Using the BO-51098 fixture, drive the retention pin from the transmitter assembly as shown.
- Remove the key blade from the transmitter assembly.
- Install the coded blank into the transmitter assembly, insure the indentation on the key blade faces the retention pin.
- Using needle nose pliers, insert the pin half way into the transmitter assembly.
- Using the BO-51098 fixture, drive the roll pin flush to the surface.
Caution:
Failure to properly support the Remote Keyless Entry (RKE) transmitter assembly while replacing the key blade may cause internal damage to the transmitter assembly.
Note:
It may be necessary to dress the pin drift on a grinder to maintain the diameter in order to drive the pin through the housing.
Note:
Use caution not to damage the surface, chrome plating, in the following steps.
Door Lock Switch Replacement
Door Lock Switch Replacement
Callout
Component Name
Preliminary Procedure
Remove the heater and air conditioning control. Refer ...
Door Lock and Ignition Lock Folding and Non-Folding Key Cutting
High Security keys are available from the service parts system.
Obtain the key code from the security card or from the GM Dealer World, Parts,
Key Code Look Up system.
If you have the key code a ...
Other materials:
Airbag Roof Side Rail Module Replacement - Rear
Airbag Roof Side Rail Module Replacement - Rear
Callout
Component Name
Warning: In order to prevent SIR deployment, personal injury,
or unnecessary SIR system repairs, do not strike the door or the door
pillar in the ...
Hub/Axle Flange and Wheel Stud Runout Inspection
Special Tools
GE-8001 Dial Indicator Set , or equivalent
Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle.
Mark the location of the wheels to the wheel studs and mark the specific
vehicle position on each tire and wheel – LF, LR, RF, RR.
Remove the tire and ...
Engine Flywheel Installation
Special Tools
EN-652 Flywheel Holder
EN-45059 Torque Angle Sensor Kit
For equivalent regional tools, refer to Special Tools.
Clean the thread in the crankshaft.
Install the crankshaft position reluctor ring (1).
Install the flywheel (2).
Install the EN-652 ...
0.006