The remote control door lock receiver only functions as an antenna, receiving the signals sent by the keyless entry transmitter and forwarding them to the body control module (BCM). The keyless entry software is contained wholly within the BCM.
This ECU does not require SPS programming or any setup procedures.
Connecting a USB Storage Device or iPod/iPhone
To connect a USB storage device, connect the device to the USB port.
To connect an iPod/iPhone, connect one end of the device’s cable to the iPod/iPhone
and the other end to the USB port.
The iPod/iPhone charges while it is connected to the vehicle if the vehicle is
in the ACC/ACCESSORY or O ...
Liftgate Adjustment
Liftgate Adjustment
Callout
Component Name
1
Liftgate
Caution: Refer to Fastener Caution.
Procedure
Loosen the 4 liftgate hinge bolts to adjust the liftgate.
Adjust the liftgate in order to obtai ...
Secondary Air Injection Check Valve Installation
Install a NEW secondary air injection check valve gasket (1).
Install the secondary air injection check valve (2).
Caution: Refer to Fastener Caution.
Install the 3 secondary air injection check valve bolts (3) and tighten
to 22 Y (16& ...