Sunroof

On vehicles with this feature, the sunroof only operates when the ignition is turned to ON/RUN or Retained Accessory Power (RAP) is active.
Open/Close: To open the sunroof, press and hold the rear of the switch. To close the sunroof, press and hold the front of the switch.
Vent: Press and hold the front of the switch to vent the sunroof.
Manually close the sunshade.
The sunroof will not operate if the vehicle has an electrical failure.

Dirt and debris may collect on the sunroof seal or in the track. This could cause an issue with sunroof operation or noise. It could also plug the water drainage system. Periodically open the sunroof and remove any obstacles or loose debris. Wipe the sunroof seal and roof sealing area using a clean cloth, mild soap, and water. Do not remove grease from the sunroof.
Sun VisorsRadio Windshield Side Garnish Molding Speaker Replacement
Radio Windshield Side Garnish Molding Speaker Replacement
Callout
Component Name
Preliminary Procedure
Remove the windshield side garnish molding. Refer to
Windshield Side Garnish Molding Replacement.
1
...
Strut, Strut Component, or Spring Replacement
Disassembly Procedure
Remove the strut assembly from the vehicle. Refer to Strut Assembly
Removal and Installation.
Note: The spring is compressed when the strut moves freely.
Install the strut assembly (2) in a suitable spring compressor ...
Coolant System Flushing
Note:
Do not use a chemical flush.
Store used coolant in the proper manner, such as in a used engine coolant
holding tank.
Do not pour used coolant down a drain. Ethylene glycol antifreeze is
a very toxic chemical.
Do not dispose of coolant into the sewer system or groun ...