Chevrolet Sonic manuals

Chevrolet Sonic Owner's Manual: Starting the Vehicle

1. Aim the RKE transmitter at the vehicle.

2. Press and release 3. Immediately after completing Step 2, press and hold.


3. Immediately after completing Step 2, press and hold the turn signal lamps flash. for at least four seconds or until
the turn signal lamps flash.

When the engine starts, the parking lamps will turn on and remain on as long as the engine is running. The doors will be locked and the climate control system may come on.

The engine will continue to run for 10 minutes. Repeat the steps for a 10-minute time extension. Remote start can be extended only once.

Remote Vehicle Start
If equipped with this feature, the engine can be started from outside the vehicle. ...

Canceling a Remote Start
To cancel a remote start, do one of the following: Aim the RKE transmitter at the vehicle and press and hold until the parking lamps turn off. Turn on the hazard warning flashers. Turn the ...

Other materials:

Engine Oil Cooler Coolant Inlet Hose Replacement (LUV)
Engine Oil Cooler Coolant Inlet Hose Replacement Callout Component Name Preliminary Procedure Open the hood. Drain the cooling system. Refer to Cooling System Draining and Filling. 1 Oil Coo ...

Control Solenoid Valve and Transmission Control Module Assembly Inspection
Verify the conditions listed below do not exist. Carefully inspect the control solenoid valve assembly connectors and pins (1, 2, 4, 6) for the condition. Repair or replace as necessary. Damage Bent pins Debris Broken retaining tab Contamination Verify there is ...

Bushing and Mating Shaft Inspection
Note: Proper bushing and corresponding mating shaft inspection should be performed before replacing the bushing, shaft, and in some cases, the component which houses the bushing. Thoroughly clean and dry the bushing and shaft surfaces before inspecting for damage. Any of the followin ...

В© 2014-2026 Copyright www.csmans.com
 
0.0064