Nissan Armada 2025-2026 Owner's Manual: System temporarily unavailable
When the Nissan Armada detects that the radar sensors are obstructed, the system will automatically deactivate to ensure safe and reliable operation.
A warning message reading "Unavailable Side Radar Obstruction" will appear in the vehicle information display, alerting the driver that the system is temporarily inactive.
During this period, the Nissan Armada safety systems dependent on radar input will remain unavailable until the obstruction is cleared and normal operating conditions are restored.
Temporary radar blockage may occur due to environmental factors such as water splashes, fog, mist, or heavy moisture in the air.
Additionally, the radar sensors on the Nissan Armada may be obstructed by physical elements including ice buildup, frost, dirt, or debris covering the sensor areas.
It is also important to note that when TOW mode (if equipped) or the trailer Blind Spot Warning (BSW) function is activated, the Nissan Armada RCTA system will automatically be disabled to prioritize towing stability and safety.
NOTE:
- If the Nissan Armada Blind Spot Warning (BSW) system becomes inoperative, both the RCTA and Intelligent Blind Spot Intervention (I-BSI) systems will also be disabled.
- When the trailer BSW function is active or TOW mode is selected, the Nissan Armada RCTA and I-BSI systems will not operate.
Action to take:
Once the obstruction or limiting condition is resolved, the Nissan Armada system will automatically resume normal operation without requiring manual intervention.
System malfunction
If the Nissan Armada RCTA system experiences a malfunction, it will automatically shut down to prevent inaccurate operation. A warning message stating "Malfunction See Owner's Manual" will appear in the vehicle information display.
NOTE:
If the Nissan Armada BSW system stops functioning, the RCTA and I-BSI systems will also be disabled as they rely on shared sensor data.
Action to take:
Safely stop your Nissan Armada, turn off the engine, and then restart it. If the warning message remains after restarting, have the system inspected as soon as possible. It is recommended that you visit an authorized NISSAN dealer for proper diagnosis and service.
How to enable/disable the RCTA system
Vehicle information display
Steering-wheel-mounted controls (right side)
Follow these steps to activate or deactivate the Nissan Armada RCTA system:
1. Press the
button until the &quo ...
System maintenance
Example
Basic information
The Nissan Armada RCTA system relies on two radar sensors (A) mounted near the
rear bumper to detect approaching vehicles.
To ensure optimal performance of the Nissa ...
Other materials:
Malfunction Indicator Lamp
A computer system called OBD II (On-Board Diagnostics-Second Generation) monitors
the operation of the vehicle to ensure emissions are at acceptable levels, helping
to maintain a clean environment. The malfunction indicator lamp comes on when the
vehicle is placed in ON/RUN, as a check to show ...
Front Side Door Trim Replacement
Front Side Door Trim Replacement
Callout
Component Name
Preliminary Procedure
Remove the front side door upper front trim panel. Refer to Front Side
Door Upper Front Trim Panel Replacement.
1
Fr ...
Front Wheel Drive Shaft Seal Replacement - Left Side
Front Wheel Drive Shaft Seal Replacement - Left Side
Callout
Component Name
Preliminary Procedures
Raise and support the vehicle. Refer to Lifting and Jacking the
Vehicle.
Remove the left wheel drive shaft. Refer to Front ...
0.0071