Chevrolet Sonic Repair Manual: Timing Belt Tensioner Installation
Special Tools
EN-45059 Angle Meter
- Clean the timing belt tensioner thread.
- Install the timing belt tensioner (2).
- Install a NEW timing belt tensioner bolt (1) and tighten the bolt in 3 passes using the EN-45059 meter.
- First pass to 20 Y (15 lb ft)
.
- Second pass to an additional 120 degrees
.
- Final pass to an additional 15 degrees
.
Caution:
Refer to Fastener Caution.
Caution:
Refer to Torque-to-Yield Fastener Caution.
Timing Belt Idler Pulley Replacement
Timing Belt Idler Pulley Replacement
Callout
Component Name
Preliminary Procedure
Remove the timing belt. Refer to Timing Belt ...
Timing Belt Tensioner Removal
Remove the tensioner bolt (1).
Remove the timing belt tensioner (2).
...
Other materials:
Rear Brake Rotor Replacement
Special Tools
CH-41013 Rotor Resurfacing Kit
CH-42450-A Wheel Hub Resurfacing Kit
For equivalent regional tools, refer to Special Tools.
Removal Procedure
Warning: Refer to Brake Dust Warning.
Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle.
...
General Description
The factory installed tires are designed to operate satisfactorily with loads
up to and including the full rated load capacity when these tires are inflated to
the recommended pressures.
The following factors have an important influence on tire life:
Correct tire pressures
Correct wheel ...
Control Valve Body Assembly Assemble (Gen 2)
Control Valve Body Assembly Assemble
Callout
Component Name
1
Valve Body Ball Check Valve (Qty: 6)
2
Valve Channel Plate
3
Control Valve Body Bolt ...
0.0053