The StabiliTrak or Traction Control System (TCS) indicator/warning light comes on briefly when the engine is started.
If the light does not come on, have the vehicle serviced by your dealer. If the system is working normally, the indicator light turns off.
If the light is on and not flashing, the TCS, and potentially the StabiliTrak system have been disabled.
If the indicator/warning light is on and flashing, the TCS and/or the StabiliTrak system is actively working.
See Traction Control/Electronic Stability Control.
Rear Wheel Speed Sensor Replacement
Removal Procedure
Warning: Refer to Brake Dust Warning.
Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle.
Remove the tire and wheel assembly. Refer to Tire and Wheel Removal
and Installation.
Remove the rear wheel speed sensor ...
Exhaust Manifold Cleaning and Inspection
Clean the exhaust manifold (1) in solvent.
Warning: Wear safety glasses in order to avoid eye damage.
Dry the exhaust manifold (1) with compressed air.
An exhaust manifold leak or damage may cause an exhaust leak and may effect
OBD II system perf ...
Drive Belt Installation
Special Tools
EN-955 Locking Pins
EN-48488 Holding Wrench
For equivalent regional tools, refer to Special Tools.
Note: Ensure that the drive belt tensioner is held with EN-955?E
locking pin.
Install the drive belt.
Move the drive belt tensioner clockwise until EN- ...