Chevrolet Sonic Owner's Manual: Automatic Transmission Shift Lock Control Function Check

Chevrolet Sonic Owner's Manual / Vehicle Care / Vehicle Checks / Automatic Transmission Shift Lock Control Function Check

Warning

When you are doing this inspection, the vehicle could move suddenly. If the vehicle moves, you or others could be injured.

1. Before starting this check, be sure there is enough room around the vehicle. It should be parked on a level surface.

2. Apply the parking brake. Be ready to apply the regular brake immediately if the vehicle begins to move.

3. With the engine off, turn the ignition on, but do not start the engine. Without applying the regular brake, try to move the shift lever out of P (Park) with normal effort. If the shift lever moves out of P (Park), contact your dealer for service.

Starter Switch Check

Warning When you are doing this inspection, the vehicle could move suddenly. If the vehicle moves, you or others could be injured. 1. Before starting this check, be sure there is enough room aroun ...

Ignition Transmission Lock Check

While parked, and with the parking brake set, try to turn the ignition to LOCK/OFF in each shift lever position. For automatic transmission vehicles, the ignition should turn to LOCK/OFF only ...

Other materials:

Special Tools (MIT Tool Instructions)
Bluetooth Pairing for Vehicles with Radio RPO: UF7 Either reset the pin code on the radio to 0000, or go under Device Info on the radio and see what the pin code is (to enter it later on the MIT). Turn the BT discoverable ON in the radio Bluetooth settings. Press Pair De ...

Rear Window Panel Trim Replacement
Rear Window Panel Trim Replacement Callout Component Name Preliminary Procedures Remove the body lock pillar upper trim panel. Refer to Body Lock Pillar Upper Trim Panel Replacement. Remove the body rear seat back trim pa ...

K20 Engine Control Module: Programming and Setup
Special Tools EL-49642 SPS Programming Support Tool For equivalent regional tools, refer to Special Tools. Note: DO NOT program a control module unless directed to by a service procedure or a service bulletin. If the control module is not properly configured with the correct ...

0.008