While parked, and with the parking brake set, try to turn the ignition to LOCK/OFF in each shift lever position.
On all vehicles, the ignition key should come out only in LOCK/OFF.
Contact your dealer if service is required.
Automatic Transmission Shift Lock Control Function Check
Park Brake and P (Park) Mechanism CheckImmobilizer System Component Programming
This procedure will learn the immobilizer function. If the battery voltage is
low, charge the battery before proceeding with the learn. If the body control module
(BCM) or engine control module (ECM) have been replaced, they must be programmed
before performing this learn procedure.
Dependin ...
Piston and Connecting Rod Disassemble
Remove the piston with connection rod. Refer to Piston, Connecting Rod,
and Bearing Removal.
Note: Note installation position of the piston in respect of the
connection rod.
Detach the piston from the connection rod.
Note: Do not damage the bore.
Remove ...
Lock Cylinder Coding - Ignition
The ignition lock cylinder uses 8 key cut positions, 1?E. The ignition cylinder
tumblers (3) are located on alternate sides of the cylinder (5). They are not snap-in
and are not self-retaining. It follows the key code with the first tumbler being
the first depth of the ke ...