The battery is not rechargeable. To replace the battery:
Caution
When replacing the battery, do not touch any of the circuitry on the transmitter. Static from your body could damage the transmitter.
1. Press the button on the transmitter to extend the key.
2. Remove the battery cover by prying with a finger.
3. Remove the old battery.
4. Insert the new battery, positive side facing up. Replace with a CR2032 or equivalent battery.
5. Snap the battery cover back on to the transmitter.
Programming Transmitters to the Vehicle
Remote Vehicle StartTire and Wheel Assembly Balancing - On-Vehicle
Special Tools
EL-38792-A Electronic Vibration Analyzer (EVA) 2
If after following the tire and wheel vibration diagnostic process, some amount
of tire and wheel vibration is still evident, an on-vehicle high-speed spin balancer
may be used to perform an on-vehicle balance in an attempt ...
Starter Replacement (LUV)
Removal Procedure
Disconnect the battery negative cable. Refer to Battery Negative Cable
Disconnection and Connection.
Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle.
If equipped with a front suspension skid plate, remove the drivetrain
...
Fuel Pressure Relief
Special Tools
EN-34730-91 Pressure Tester
For equivalent regional tools, refer to Special Tools.
Warning: Gasoline or gasoline vapors are highly flammable. A fire
could occur if an ignition source is present. Never drain or store gasoline
or diesel fuel in an open container, due ...