|
Callout |
Component Name |
|---|---|
|
Preliminary Procedure
Remove the seat head restraint. Refer to Driver or Passenger Seat Head Restraint Replacement. |
|
|
1 |
Driver or Passenger Seat Head Restraint Guide (Qty:?€‰2) Procedure
Using a suitable flat-bladed tool, slide the tool on the inside of the guide until it finds the slot. Then push the tool forward pulling the guide tab inward, while pulling upward to remove the guide from the seat back frame. |
Headrests
Driver or Passenger Seat Head Restraint ReplacementSIR Seatbelt Pretensioner Handling Warning
Warning: When carrying an undeployed inflatable restraint seat belt
retractor pretensioner:
Do not carry the seat belt pretensioner by the seat belt webbing or
pigtail connector, if equipped.
Carry the seat belt pretensioner by the housing, keeping hands and fingers
away fro ...
Bushing and Mating Shaft Inspection
Note: Proper bushing and corresponding mating shaft inspection should
be performed before replacing the bushing, shaft, and in some cases, the component
which houses the bushing. Thoroughly clean and dry the bushing and shaft surfaces
before inspecting for damage.
Any of the followin ...
Transmission Control Replacement
Transmission Control Replacement
Callout
Component Name
Preliminary Procedures
Remove the front floor console. Refer to
Front Floor Console Replacement.
Disconnect the range selector lever cable. Refer
to Range Select ...