Chevrolet Sonic Repair Manual: Floor Carpet Drying
If the carpet or the pad or insulator is wet, use the following criteria for drying or for replacing the components:
- For a 1-piece carpet assembly bonded to a cotton or a fiber padding, replace the entire assembly.
- For a 2-piece carpet assembly with a cotton or a fiber padding, replace the padding only. While the carpet is out of the vehicle, dry the carpet using the method described below.
- For a 1-piece carpet assembly bonded to a foam padding or attached to a synthetic padding, dry the carpet using the method described below.
- For a 2-piece carpet assembly with a synthetic padding, dry the assembly using the method described below.
- If you observe puddles of liquid on the carpet face, use a wet vacuum to remove the excess moisture.
- Blot the face of the carpet with a towel in order to absorb as much moisture as possible.
- Point a fan at the affected area and air dry the carpet.
Floor Panel Carpet Replacement
Floor Panel Carpet Replacement
Callout
Component Name
Preliminary Procedures
Remove front seats. Refer to Driver or Passenger Seat ...
Other materials:
Radiator Grille Opening Cover Replacement (Upper Grille Cover)
Radiator Grille Opening Cover Replacement
Callout
Component Name
Preliminary Procedure
Remove the radiator upper grille. Refer to Front Upper Grille Replacement.
1
Radiator Grille Opening Cover ( ...
Driver or Passenger Seat Head Restraint Replacement
Driver or Passenger Seat Head Restraint Replacement
Callout
Component Name
1
Driver or Passenger Seat Head Restraint
Procedure
Raise the headrest to the full upward position.
Depress the flush button on the he ...
Neutral - Engine Running (Gen 2)
When the gear selector is moved to the Neutral (N) position, the hydraulic and
electrical system operation is identical to Park (P) range. However, if Neutral
is selected after the vehicle was operating in Reverse (R), the normally-low 35R
pressure control solenoid is commanded OFF and the fol ...
0.006