To replace the front fog lamp bulb:
1. Locate the fog lamp located under the front fascia.
2. Disconnect the electrical connector from the fog lamp bulb assembly.
3. Remove the bulb by turning it counterclockwise and pulling it straight out of the assembly.
4. Install the new bulb by turning it clockwise into the assembly.
5. Reconnect the electrical connector.
Parking/Turn Signal Lamp
Fog Lamps (RS)Emblem/Nameplate Replacement
Caution: Refer to Exterior Trim Emblem Removal Caution.
The part and vehicle surface should be 21?°C (70?°F) prior to installation.
The vehicle should remain inside in a temperature range of 21?°C (70?°F) for
1 hour after assembly to allow the adhesive to develop sufficient bo ...
Catalytic Converter Replacement (LUV)
Removal Procedure
Warning: Refer to Exhaust Service Warning.
Warning: Refer to Protective Goggles and Glove Warning.
Remove the exhaust manifold heat shield. Refer to Exhaust Manifold Heat
Shield Replacement.
Remove the catalytic converter heated oxygen senso ...
Oil Level Indicator and Tube Installation
Install a NEW oil level indicator tube gasket.
Install the oil level indicator tube (2).
Caution: Refer to Fastener Caution.
Install the oil level indicator tube bolt (1) and tighten to 15 Y (11 lb ft).
Install the oil dipstick.
...