Chevrolet Sonic Repair Manual: Front Wheel Drive Shaft Seal Replacement - Left Side
Special Tools
- DT-446 Installer Drift
- DT-7004 Slide Hammer
- DT-23129 Universal Seal Remover
For equivalent regional tools, refer to Special Tools.
- Removal Procedure
-
- Raise and support the vehicle. Refer to Lifting and Jacking the Vehicle.
- Remove the front suspension skid plate, if equipped. Refer to Drivetrain and Front Suspension Frame Skid Plate Replacement.
- Remove the left wheel drive shaft from the transmission. Refer to Front Wheel Drive Shaft Replacement.
- Remove the left front wheel drive shaft oil seal (3) using the DT-7004 hammer and the DT-23129 remover(1).
- Installation Procedure
-
- Coat the NEW left front wheel drive shaft oil seal (2) with transmission fluid.
- Install the NEW left front wheel drive shaft oil seal (2) using the DT-446 drift and hammer (1).
- Install the left wheel drive shaft. Refer to Front Wheel Drive Shaft Replacement.
- Install the front suspension skid plate, if equipped. Refer to Drivetrain and Front Suspension Frame Skid Plate Replacement.
- Lower the vehicle.
Front Wheel Drive Shaft Seal Replacement - Left Side
Front Wheel Drive Shaft Seal Replacement - Left Side
Callout
Component Name
Preliminary Procedures
Raise and support the vehicle. R ...
Front Wheel Drive Shaft Seal Replacement - Left Side
Front Wheel Drive Shaft Seal Replacement - Left Side
Callout
Component Name
Preliminary Procedure
Raise and support the vehicle. Re ...
Other materials:
Airbag Roof Side Rail Module Replacement - Rear
Airbag Roof Side Rail Module Replacement - Rear
Callout
Component Name
Warning: In order to prevent SIR deployment, personal injury,
or unnecessary SIR system repairs, do not strike the door or the door
pillar in the ...
ABS Description and Operation
This vehicle is equipped with the MGH 60 Mando electronic stability control antilock
brake system. The electronic brake control module and the brake pressure modulator
are serviced separately. The brake pressure modulator uses a four circuit configuration
to control hydraulic press ...
Fuel Injection Fuel Rail Assembly Replacement
Removal Procedure
Disconnect battery negative cable. Refer to Battery Negative Cable Disconnection
and Connection.
Remove engine cover. Refer to Engine Cover Replacement.
Remove the fuel feed pipe from fuel injection fuel rail. Refer to Fuel
Feed Pipe Replacement.
Re ...
0.0047