|
Callout |
Component Name |
|---|---|
Preliminary Procedure
|
|
|
1 |
Fuel Rail |
|
2 |
Fuel Injector |
|
3 |
Fuel Injector Seal Ring |
|
4 |
Fuel Injector Retainer Clamp |
Fuel Injection Fuel Rail Assembly Replacement
Fuel Pressure MeasurementNew Vehicle Break-In
Caution
The vehicle does not need an elaborate break-in. But it will perform better
in the long run if you follow these guidelines:
. Do not drive at any one constant speed, fast or slow, for the first
805 km (500 mi). Do not make full-throttle starts. Avoid downshifting to brake
or slo ...
Door Lock and Ignition Lock Folding Key Blade Removal and Installation
Special Tools
BO-51098 Flip Key Blade Fixture
For equivalent region tools, refer to Special Tools.
Caution: Failure to properly support the Remote Keyless Entry
(RKE) transmitter assembly while replacing the key blade may cause internal
damage to the transmitter assembly. ...
Tire and Wheel Balancing (Collet Cone Selection)
Important: Never use the hub cap bore to center the wheel onto
the balancer. The pilot bore (on the hub side of the wheel) is machined
to be concentric to very tight non - standard tolerances. The bottom cap
bore is not machined to this same degree of precision.
Accurate mac ...