Chevrolet Sonic Repair Manual: Intake Manifold Installation (1.6L LDE)
- Clean the sealing surfaces.
- Insert the NEW gasket.
- Install the intake manifold (2) and the 7 intake manifold bolts (1) and
tighten to 20 Y (15 lb ft)
.
- Install the intake manifold support (1) and the 2 bolts (2, 3) and tighten
to 8 Y (71 lb in)
.
Caution:
Refer to Fastener Caution.
Intake Manifold Installation
Clean the sealing surfaces.
Install the intake manifold (1) along with a NEW intake manifold gasket.
Caution: Refer to Fastener Caution.
Install the 6 intak ...
Intake Manifold Installation (1.8L LUW and LWE)
Clean the sealing surfaces.
Install 4 NEW gaskets.
Caution: Refer to Fastener Caution.
Install the intake manifold (2) and the 7 intake manifold bolts (1 ...
Other materials:
Plastic Collar Quick Connect Fitting Service
Removal Procedure
Warning: Refer to Gasoline/Gasoline Vapors Warning.
Note: There are several types of plastic collar fuel and evaporative
emission quick connect fittings used on this vehicle.
Bartholomew (1)
Q Release (2)
Squeeze to Rele ...
General Description
The factory installed tires are designed to operate satisfactorily with loads
up to and including the full rated load capacity when these tires are inflated to
the recommended pressures.
The following factors have an important influence on tire life:
Correct tire pressures
Correct wheel ...
Transmission Rear Mount Replacement
Removal Procedure
Raise and support the vehicle. Refer to
Lifting and Jacking the Vehicle.
Remove and DISCARD the rear transmission mount bracket
to rear mount through bolt (1).
Remove rear transmission mount to frame bolt (3).
Push and hold ...
0.0106